Anhui Explosion-proof Floodlight
Explosion-proof Floodlight
In order to meet the needs of fixed lighting in flammable and explosive places and related roads, indoor and outdoor operations and construction sites, our company has developed a model of indoor strong light Explosion-proof lights can work safely in flammable and explosive places.
It adopts two-cavity explosion-proof, meets the latest requirements for explosion-proof lamps, and can work safely and reliably in flammable and explosive dangerous places.
The lamp body is made of lightweight alloy material, which has high strength, strong corrosion resistance and good impact resistance. The transparent part is made of special tempered glass with large arc and high temperature resistance, which expands the heat dissipation space, reduces the temperature rise and improves the efficiency of the bulb. Service life
The surface of the lamp adopts the latest spraying technology, does not discolor, does not rust, can be waterproof and rainy, and can also be used outdoors for a long time
Small size, light weight, can be used in boom type or wall-mounted type , ceiling type and light pole type and other installation methods, simple and convenient operation
Rated voltage
Explosion-proof mark/
Power factor greater than
Protection level
Anti-corrosion level< br/> Insulation level
Inlet thread and cable size/,~
Overall dimensions lamp holder ballast box
Weight lamp holder ballast box
Equipped with light source
The order number is matched with the rated power of the light source, the average service life of the luminous flux
Confirm the installation position of the lamp and ballast box, select the appropriate installation method, and prepare a special three-core cable of corresponding length.
After installing and fixing the lamp and ballast box with screws, use an Allen wrench to unscrew the side cover screws, remove the side cover and pass one end of the prepared three-core cable through the explosion-proof connector and introduce it Connect the wiring in the wiring cavity to the corresponding position of the wiring base. After connecting the yellow wire to the ground wire, tighten the side cover screws, then tighten the explosion-proof connector and cable compression screws.
. Pass one end of the three-core power cable through the introduction device of the input port of the ballast box and connect it to the terminals marked on the binding posts in the ballast box.
. Connect one end of the cable connected to the power supply through the introduction device of the ballast input port to the input terminal. Then close the tail cover of the ballast box and tighten the screws. Connect the other end of the cable to the input terminal. Lighting can be achieved by turning on the power supply according to explosion-proof requirements
. The special ballast box provided by our company must be used.
When installing and maintaining lamps, the power supply must be cut off first.
The center temperature of transparent parts is relatively high and cannot be touched directly by hand.
When replacing the bulb, the same type of bulb should be used. If the bulb model or power is changed, the corresponding ballast should be replaced.
The company has passed the international quality system audit and certification, and strictly implements the international quality management system standard production to ensure that the product quality fully meets the national standards and design requirements. The product is subject to an annual warranty (the light source is guaranteed for one year) within the year from the date of purchase. , our company will be responsible for free maintenance if any malfunction occurs under normal use of the product.
Anhui NFE190-NFE190 explosion-proof floodlight